forum.cncdrive.com

Hello, i am using uccnc version 1.2047 with the UC400ETH.

I was setting up jog/feedrates with my xbox controller (in demo mode) I found something strange:
When the override limit is active and I jog some axis (the x-axis in my case) with my xbox controller or keyboard, and i hit the reset button (while i am jogging) the reset state is activated but my axis keeps movingm even when i let go of the jog button. (eg key or xbox controller)

Its not possible to do some jogging when the machine is a reset state, so i assume this is a bug.

This bug was already corrected in UCCNC test version 1.2103.
Copy from the release notes:

- In demo mode the reset did not stop the jog if the jog key was held down while triggering the reset. This could not cause an issue for any machines, because it only effected the demo modes which can't control a machine.

Ah ok. Than i just have to wait until the new version comes out

The UCCNC beta download mentioned can be found in this forum at
http://www.forum.cncdrive.com/viewtopic.php?f=2&t=240&start=40#p8188

I hope this helps.

The test version with the bug fix has been removed due to other bugs, so is not currently available.

Gerry is correct. The test release 1.2103 was removed, because customers and also we explored some bugs which were introduced due to some of the upgrades in that release.
We currently working on fixing them and as soon as we will be ready then we will release a new test version.