Page 1 of 1
Re: Tool Table View Glitch
Posted:
Thu Feb 01, 2018 1:07 amby Dan911
I can't help but feel this is a baited post but I'll go for it and ask...lol
Doesn't .5 = .50000000000000000000000000000000000000000000000000000000
Re: Tool Table View Glitch
Posted:
Thu Feb 01, 2018 8:05 amby cncdrive
The tooltable values strings are not formatted and so 1.2 will be 1.2 and not 1.2000 and 1.23 will be 1.23 and not 1.2300.
The question is if they should be formatted at all?
Re: Tool Table View Glitch
Posted:
Thu Feb 01, 2018 8:59 amby dezsoe
IMHO yes, because on the tools screen there are also 4 decimals and in a table it's easier to view. But only the length and diameter columns. The slot# could be smaller.
Re: Tool Table View Glitch
Posted:
Fri Feb 23, 2018 4:49 pmby cncdrive
Tooltable is now formatted to show digits as other DROs setup in the UCCNC settings. Version is 1.2103.