cncdrive wrote:I did not take it as critism, I just thought it is funny, because you said "simple graphics" while the graphics algorithms of the UCCNC is very complex.
To be fair I said "relatively simple graphics". I'm comparing what I see on (say) modern 3D games screens with what I see on the screen of a motion controller.
Anyway, all it is, is that some of my DTHC customers ask me when I'm going to support UCCNC. To answer that I needed to experiment with it and ask questions when I hit issues. I've been diddling with Mach3 for over a decade but I've only been diddling with UCCNC for a couple of weeks so if some of my questions sound dumb I apologize. I now know that when they ask "will it run on my Mach3 XP 'brick', I can advise them accordingly and they can make their decision.
Meanwhile I'll look at getting a more up to date PC and carry on experimenting from there.
Thanks again