I can't help but feel this is a baited post but I'll go for it and ask...lol
Doesn't .5 = .50000000000000000000000000000000000000000000000000000000
Tool Table View Glitch
4 posts
• Page 1 of 1
Re: Tool Table View Glitch
by Dan911 » Thu Feb 01, 2018 1:07 am
- Dan911
- Posts: 613
- Joined: Mon Oct 31, 2016 1:22 am
- Location: USA
Re: Tool Table View Glitch
by cncdrive » Thu Feb 01, 2018 8:05 am
The tooltable values strings are not formatted and so 1.2 will be 1.2 and not 1.2000 and 1.23 will be 1.23 and not 1.2300.
The question is if they should be formatted at all?
The question is if they should be formatted at all?
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Tool Table View Glitch
by dezsoe » Thu Feb 01, 2018 8:59 am
IMHO yes, because on the tools screen there are also 4 decimals and in a table it's easier to view. But only the length and diameter columns. The slot# could be smaller.
- dezsoe
- Posts: 2093
- Joined: Sun Mar 12, 2017 4:41 pm
- Location: Csörög, Hungary
Re: Tool Table View Glitch
by cncdrive » Fri Feb 23, 2018 4:49 pm
Tooltable is now formatted to show digits as other DROs setup in the UCCNC settings. Version is 1.2103.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests