Would it be possible to have the Toolpath show the X,Y & Z arrows on each of the views correctly?
139 Toolpathview45 Sets the toolpath to a 45° look viewing mode.
140 Toolpathviewright vSets the toolpath to a right side look viewing mode.
141 Toolpathviewleft vSets the toolpath to a left side look viewing mode.
142 Toolpathviewtop vSets the toolpath to a top side look viewing mode.
143 ToolpathviewISO Sets the toolpath to Isometric viewing
toolpath UCS arrows (minor issue)
2 posts
• Page 1 of 1
toolpath UCS arrows (minor issue)
by Robertspark » Fri Oct 27, 2017 4:57 pm
- Attachments
-
- Button # 141
- toolpath - Button 141.png (2.24 KiB) Viewed 5707 times
-
- Button # 140
- toolpath - Button 140.png (2.93 KiB) Viewed 5707 times
-
- Button # 139
- toolpath - Button 139.png (2.02 KiB) Viewed 5707 times
UCCNC Macro Manual v1.2113 - https://drive.google.com/drive/folders/ ... sp=sharing
- Robertspark
- Posts: 1892
- Joined: Sat Sep 03, 2016 4:27 pm
Re: toolpath UCS arrows (minor issue)
by Robertspark » Fri Oct 27, 2017 4:59 pm
I noticed it after changing the toolpath for lathe X + Z, view / button # 141
142 & 143 look fine, its the others that look a bit difficult to read
142 & 143 look fine, its the others that look a bit difficult to read
- Attachments
-
- Button # 143
- toolpath - Button 143.png (2.29 KiB) Viewed 5705 times
-
- Button# 142
- toolpath - Button 142.png (2.62 KiB) Viewed 5705 times
UCCNC Macro Manual v1.2113 - https://drive.google.com/drive/folders/ ... sp=sharing
- Robertspark
- Posts: 1892
- Joined: Sat Sep 03, 2016 4:27 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 23 guests