UCCNC/AXBB-E loses position. Crashes machine.

[mr_guy99493]

Jogging after being in reset causes the system to lose position.

Video showing zeroed machine + DRO.
Jog, reset, jog, reset, jog, reset, jog -> axis position increases even while machine is not moving.
Go to zero -> position of machine is nowhere near zero as seen on DRO. 30 millimeters off.

https://youtu.be/o7Z6cJrdDCA

Now I have a big chunk missing from my vice...

[mr_guy99493]

Traced problem to servo drivers. Appears to not be UCCNC/AXBB-E problem.