Yes, sticky R for canned cycles was just implemented and to be tested.
Should be working fine in the next UCCNC release.
G83 and G73 canned cycle bug
12 posts
• Page 2 of 2 • 1, 2
Re: G83 and G73 canned cycle bug
by cncdrive » Thu Feb 10, 2022 4:25 am
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: G83 and G73 canned cycle bug
by tarnish1 » Thu Feb 10, 2022 10:25 am
Great news, I will look forward to the next release.
Phil
Phil
- tarnish1
- Posts: 3
- Joined: Fri Jul 16, 2021 8:32 am
12 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 10 guests