Version 1.2115 LED number errors

[ger21]

On the Diagnostic page for the UC300-M44, all the LEDs are wrong for ports 2-5, except for pins 1&2 for port 2. All the rest use these same two LED #'s.

[cncdrive]

Thanks. Dezsoe will check it out, he is on holidays now, but will get back on the 5th.

[Battwell]

i had reported to deszoe that the diagnostic pins for uc300eth 5lpt were wrong in version 113 too. i think he fixed those

[ger21]

I went through most of them as I put the finishing touches on my new screenset, and I think that all the rest were correct.