Hello Balasz,
Mach3 V. 3.043.66, UC300ETH5LPT, Plugin 1.006 or 1.007
..
..
G91G31Z-20F300 (not supposed to trigger at this point, only approach move)
G0 X5
..
..
The axis moves but when poistion reached it freezes. If I hit the probe then it moves to next step.
Same behavior in VB script.
I have same application in other machine but UC300USB and works perfectly.
I need to catch up with my probing routine.
Thanks for help
Alberto FUL
Mach3 & G31
5 posts
• Page 1 of 1
Mach3 & G31
by Alberto FUL » Thu Jan 12, 2017 2:42 pm
- Alberto FUL
- Posts: 39
- Joined: Thu Jan 12, 2017 1:48 pm
- Location: Italy
Re: Mach3 & G31
by cncdrive » Thu Jan 12, 2017 9:21 pm
The issue with the probe with the Mach3 plugin when ran to endpoint without triggering the probe was fixed.
The problem was in both the UC400ETH and UC300ETH plugins, so I will attach both plugins for testing.
The problem was in both the UC400ETH and UC300ETH plugins, so I will attach both plugins for testing.
- Attachments
-
UC400ETH V1_013.dll- (297.5 KiB) Downloaded 933 times
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Mach3 & G31
by cncdrive » Thu Jan 12, 2017 9:23 pm
The UC300ETH test plugin attached here.
- Attachments
-
- UC300ETH V1_008.dll
- (669 KiB) Downloaded 941 times
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Mach3 & G31
by Alberto FUL » Fri Jan 13, 2017 10:55 am
Thank You very much.The V1_008 works good.
Very efficient service.
Thanks again
Very efficient service.
Thanks again
- Alberto FUL
- Posts: 39
- Joined: Thu Jan 12, 2017 1:48 pm
- Location: Italy
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests