Ver 1.2110. Spindle relay + MPG: fail

[Fagge]

Controller AXBB-E
M3/M4 Spindle Relay: Connected to Port1 Pin 2+3

The problem: The spindle relay switching off, when i switching between the X / Y / Z buttons in the MPG / JOG menu.
But the Spindle icon in RUN menu still lights up green & indicates Spindle ON.
This wrong event always happens to me in this version "1.2110"

[cncdrive]

Post your profile file.

[Fagge]

Here comes the Profile.
This was no problem in the previous version.
And when I installed this latest version, I didn't save any files from before. All configurations were re-made.

[dezsoe]

Do you switch the MPG axis with the external buttons or on the jog screen? (You have also some interesting input configuration on port 2.)

[Fagge]

It doesn't matter if I press via external buttons or via the mouse in the jog screen. The spindle stops, but indicates ON.

I tried to combine Cyclestart and Pause via the same button. I will try to remove this combo...
Yes I share the Home switches with an inverted probe on the same input, when only one function is used at same time.

[dezsoe]

OK, thanks, I'll check it later today. (Now I don't have an AXBB with me.)

[dezsoe]

Sorry, I could test it only now. The issue exists.

[Fagge]

Okay.
Good to get it confirmed. Then we wait for a future update

[cncdrive]

We could reproduce this issue and fixed it, it will be OK in the next release.