forum.cncdrive.com

Hi, if I use uc300eth with mach3 and bob ltp the soft limit slow zone function does not slow down, if I disconnect uc300eth and connect lpt directly to bob slow zone it works perfectly, same computer same configuration , plugin version 1_022 mach3 version 066.
Is this feature hare supported for the plugin? exist solution?
Thx for reply

In our opinion slow zone function of Mach3 is not a good implementation.
How our plugin handles the softlimits is that it precalculates the trajectory, so it starts to deccelearate in time to stop on the softlimit.
This way there is no need for slowzone and so our plugin not supporting that, but instead it deccelerates from the current velocity to 0 when reaching the softlimits.