forum.cncdrive.com

Hallo from germany,

I have my second AXBB-E controller and after converting a mill to cnc using uccnc, i now want to do the same with a lathe but using mach3 turn.
I no have my servos running, homing also works but i have a few Problems:

My changes in the axbbe plugin manager do not save.
Every time i restart they are lost. All other settings stay.

And the second problem is, i want to have my spindle controlled via pwm and vfd.
cw works but ccw doesnt.
It switches the output on, but nothing happens.

Next Problem is the spindle only runs for a few seconds sometimes longer and sometimes less.
It shuts the outputs off without doing me anything...
I reset the controller but doesnt change anything.

I would be really thankfull if someone could help me.

Can you please post your mach3 xml settings file?

i cant upload the file because it is "identified as a possible attack vector"...

Please ZIP the file.

thanks, now it worked.

Thank you.
I forwarded the issue to my collegue who works on the Mach3 plugin developments.
I'll let you know what he found asap.

Thanks

cncdrive wrote:Thank you.
I forwarded the issue to my collegue who works on the Mach3 plugin developments.
I'll let you know what he found asap.

I found another intersting thing.
When ive opened the axbb in/out Monitor, i can change FRO and SRO with my potis. But when i close it, Feed and spindle speed doesnt change anymore...

Also all the poblems stay when using mach 3 turn with my mill.

We have checked your xml file and the issues you reported and the problem is with your xml file.
The issue is that there are illegal characters in it which is because you using a cracked license key.
The solution is to use a proper purchased Mach3 license key.

You can test this with you removing your mach1lic.dat license file from the Mach3 folder and then run Mach3 2 times and after the 2nd time it will run fine.