AXBB-E Mach3 Homing Problem

[MDT]

Good morning everyone, I'm Matteo and I'm new to this forum since I bought myself an AXBB-E that replaces my old controller port. I have 2 issues that I can't solve with this tab and I wanted to know if anyone can give me any suggestions.

- First problem: I use Mach3 and when I go to do the Homing of the axes, start the master engine and not the slave of the Y-axis.

- Second problem: the Probe works perfectly until I connect it to the spindle bit. when I connect it it doesn't work anymore.

Thanks to who can help me.

[cncdrive]

I beleive there is a setting in Mach3 to be selected to make the master to home together with the slave.
I don't understand your second problem.

[MDT]

I have already checked "Home Slave with Master Axis" in "General Config." but it continues to give the problem.
I attach the Mach3Mill.xml file to show you how Mach3 is configured.
As for the Probe, I solved it by reversing the polarity of the plate and the crocodile attached to the cutter.

TKS.

[ger21]

Home slave with master should NOT be checked if you have two home switches.

[MDT]

I only have 1 home switch for the two axes.
Is the xml file I sent the right configuration file?

[ger21]

I didn't look at your .xml
In that case, then you do want to check Home Slave with Master.

[MDT]

I attach the Mach3 xml connected to the AXBB-E. Today I removed the check from "A is angular" in the General Config, but the A axis, slave of the Y axis does not move in homing