forum.cncdrive.com

Posted: **Thu Apr 01, 2021 12:53 am**

Just upgraded to UC300ETH on win 10 with mach3 from vanilla Mach3/paralell port on win XP. Everything is working, except ref all home operates at about 1 inch per minute!
Mach3 homing set to 20% as it was before install.
Tried upping to 60% with no improvement.

Posted: **Thu Apr 01, 2021 9:59 pm**

Reverted to earlier .013 version of dll, instead of 022 version which works.

forum.cncdrive.com

UC300ETC/Mach3 super slow homing speed.

UC300ETC/Mach3 super slow homing speed.

Re: UC300ETC/Mach3 super slow homing speed.