Hi Tweakie,
Could you please post a short piece of g-code file in which this issue can be seen?
Also your Mach3 xml file would be good to have.
Then I will ask my collegue to test and debug it.
Mach3 Plugin for the UC400ETH
14 posts
• Page 2 of 2 • 1, 2
Re: Mach3 Plugin for the UC400ETH
by cncdrive » Tue Mar 09, 2021 5:02 pm
- cncdrive
- Site Admin
- Posts: 4984
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Mach3 Plugin for the UC400ETH
by Tweakie.CNC » Wed Mar 10, 2021 11:41 am
Hi,
I have attached the Gcode file for the test made in my last post and also the .xml file I used.
Thank you for taking the time to look a this.
Tweakie.
I have attached the Gcode file for the test made in my last post and also the .xml file I used.
Thank you for taking the time to look a this.
Tweakie.
- Attachments
-
Allan1.zip- (30.04 KiB) Downloaded 587 times
-
- Plugin test 1.txt
- (121 Bytes) Downloaded 572 times
-
Tweakie.CNC - Posts: 127
- Joined: Wed Jul 31, 2019 7:58 am
- Location: London UK
Re: Mach3 Plugin for the UC400ETH
by cncdrive » Wed Mar 10, 2021 12:58 pm
OK, I will forward the files to my collegue for testing. Thank you.
- cncdrive
- Site Admin
- Posts: 4984
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Mach3 Plugin for the UC400ETH
by Tweakie.CNC » Sat Apr 24, 2021 9:59 am
Hi Guys,
It’s been a while now, is there any news about the M11/M10 switching delays found in the Mach3 plugin ?
Many thanks,
Tweakie.
It’s been a while now, is there any news about the M11/M10 switching delays found in the Mach3 plugin ?
Many thanks,
Tweakie.
-
Tweakie.CNC - Posts: 127
- Joined: Wed Jul 31, 2019 7:58 am
- Location: London UK
14 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 5 guests