Just upgraded to UC300ETH on win 10 with mach3 from vanilla Mach3/paralell port on win XP. Everything is working, except ref all home operates at about 1 inch per minute!
Mach3 homing set to 20% as it was before install.
Tried upping to 60% with no improvement.
UC300ETC/Mach3 super slow homing speed.
2 posts
• Page 1 of 1
UC300ETC/Mach3 super slow homing speed.
by Chrismolloy » Thu Apr 01, 2021 12:53 am
- Chrismolloy
- Posts: 3
- Joined: Thu Apr 01, 2021 12:46 am
Re: UC300ETC/Mach3 super slow homing speed.
by Chrismolloy » Thu Apr 01, 2021 9:59 pm
Reverted to earlier .013 version of dll, instead of 022 version which works.
- Chrismolloy
- Posts: 3
- Joined: Thu Apr 01, 2021 12:46 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests