forum.cncdrive.com

Hello

First of all, I am fairly new to cnc and UCCNC, but picking things up fast, thanks to a excelent piece of software and controllerboard

However, I have a question. When I reach my soft limit I will allways get a message on the screen telling me so. This is all and well, but since I often use my xbox controller for the machine, it is a bit annoying to have to run to the computer to clear this message. Is there any way to have it autoclear, or just dont pop up?

Thanks for any help.

Hi,

There is an option on the Configuration/Appearance page, a checkbox with that you can suppress that message window and then only a statusmessage is what is shown when the softlimits gets reached.