Page 1 of 1
UCCNC Probing
Posted:
Sat Sep 28, 2024 6:21 pmby nyracerxxx
I have working fine, just wondering if there's a way to retract after probing to set distance. ie Probe Z, zero axis, retract .25" Like that?
Re: UCCNC Probing
Posted:
Sun Sep 29, 2024 8:53 pmby cncdrive
If you probing from a macro then sure, you can code a
G91
G0 Z-10
G90
This will retract the Z with -10 relative to the probed Z coordinate.
Re: UCCNC Probing
Posted:
Mon Sep 30, 2024 9:56 pmby nyracerxxx
Yes I figured that.
Is there a way to edit the macro's on the probe page?
Re: UCCNC Probing
Posted:
Tue Oct 01, 2024 6:51 pmby cncdrive
On the probing screen there is a Retract value and an Enable retract button.