Page 1 of 1
UCCNC license file not working
Posted:
Wed Jun 26, 2024 4:12 pmby 750ml
I received a license file [UCCNClicense_CD2325.txt], which I copied to the C:\UCCNC subdirectory. I thought that would be recognized by the software but it still opens in demo mode. How do I fix this?
Re: UCCNC license file not working
Posted:
Wed Jun 26, 2024 6:15 pmby cncdrive
Follow the steps in the motion controller users manual please.
Re: UCCNC license file not working
Posted:
Wed Jun 26, 2024 9:33 pmby 750ml
Actually, I did follow the manual, sparse as it is on details.
Re: UCCNC license file not working
Posted:
Thu Jun 27, 2024 10:18 amby cncdrive
Did you setup the network card IP address as described in the users manual?
What does the UCx00 utilty tool says when you test the connection?
Re: UCCNC license file not working
Posted:
Thu Jun 27, 2024 12:30 pmby 750ml
There was a typo when setting up the ethernet connection. Once resolved the license file was accepted.