Stepcraft M1000 rotary axis calibration
Posted: Tue Jun 11, 2024 8:15 amHi All,
i'm very much of a beginner. Having purchased a 4th axis from Stepcraft, I'm having issues that when giving an A-command for the axis to move (turn), if i gave A30, it would turn 20 degrees. Whatever the A-value is, the is a 0.67 ratio coming to the actual move. Where can I adjust this? When I try to adjust the travel done by steps, the stepper motor makes some funny quiet struggling noise...
Could someone help please? Thank you
i'm very much of a beginner. Having purchased a 4th axis from Stepcraft, I'm having issues that when giving an A-command for the axis to move (turn), if i gave A30, it would turn 20 degrees. Whatever the A-value is, the is a 0.67 ratio coming to the actual move. Where can I adjust this? When I try to adjust the travel done by steps, the stepper motor makes some funny quiet struggling noise...
Could someone help please? Thank you