Profile fails to load....
Posted: Thu Jun 06, 2024 3:11 pmI need help with a problem.
I recently upgraded the PC that controls my CNC, and whilst doing so, I also made some tweaks to the screenset and upgraded to v1.2116. These tweaks were done on my main PC, not the one controlling the machine.
On the CNC PC, I have a UCCNC desktop icon with the target of C:\UCCNC\UCCNC.exe /p KRS-CNC. This launches UCCNC, but for some reason runs the Default profile, not KRS-CNC. I've checked that all necessary files are in the correct directories (or at least I think I have!).
I can simply get around this problem by selecting the KRS-CNC profile from the list, which restarts and loads correctly. But when I close UCCNC and run it again, it loads the Default profile. When the KRS-CNC profile is selected, it runs just fine.
Could it be a problem with v1.2116?
I recently upgraded the PC that controls my CNC, and whilst doing so, I also made some tweaks to the screenset and upgraded to v1.2116. These tweaks were done on my main PC, not the one controlling the machine.
On the CNC PC, I have a UCCNC desktop icon with the target of C:\UCCNC\UCCNC.exe /p KRS-CNC. This launches UCCNC, but for some reason runs the Default profile, not KRS-CNC. I've checked that all necessary files are in the correct directories (or at least I think I have!).
I can simply get around this problem by selecting the KRS-CNC profile from the list, which restarts and loads correctly. But when I close UCCNC and run it again, it loads the Default profile. When the KRS-CNC profile is selected, it runs just fine.
Could it be a problem with v1.2116?