Page 1 of 1
VistaCNC P4-S pendant not working in 1.2116
Posted:
Sat Mar 23, 2024 8:58 pmby bob_mllr
Hi,
I have a VistaCNC iMach III P4-S pendant that was working fine in V1.2113, but it is not operating correctly in 1.2116. I've sent a note to them as well, but was wondering if anything has changed in UCCNC that would effect their dll and mess with it working correctly?
Thanks,Bob
Re: VistaCNC P4-S pendant not working in 1.2116
Posted:
Sat Mar 23, 2024 11:05 pmby cncdrive
What is not working correctly?
Re: VistaCNC P4-S pendant not working in 1.2116
Posted:
Sun Mar 24, 2024 1:09 amby bob_mllr
The pendant does not activate correctly - it does not show the axis selection or the coordinates. The jog wheel does not work, or initially jogs a little then stops working. Basically does not work correctly from startup. I can post a video?
Bob
Re: VistaCNC P4-S pendant not working in 1.2116
Posted:
Thu Aug 08, 2024 5:26 pmby iiflyinverted
I just updated to version 1.2117 from 1.2115. I have a Vistacnc P-4S and it is not working properly. I am certain the plugin is loaded with the latest version. I appear to be one of several people with this problen that may have started with ver 2.116. Thanks for any assistance
Re: VistaCNC P4-S pendant not working in 1.2116
Posted:
Thu Aug 08, 2024 7:06 pmby iiflyinverted
My Vistacnc P-4s pendant works on UCCNC ver 1.2117 using the default screenset but not the 2019 screenset. Any way to fix this?
Re: VistaCNC P4-S pendant not working in 1.2116
Posted:
Sat Aug 10, 2024 10:26 amby charliem
You could always go back to the 1.2113. Just a thought.
Re: VistaCNC P4-S pendant not working in 1.2116
Posted:
Wed Oct 09, 2024 4:48 pmby iiflyinverted
Take a look at this post. It fixed my issue. The problem was occurring for me when using the 2019 screenset and not the default screenset.
viewtopic.php?f=3&t=5161