forum.cncdrive.com

Hello everyone,
Being a novice in CNC; I need to help for connect my leadshine CSD508 Driver to my UCCBB1 board. I would like to do my first tests and run the motor. I am having trouble configuring the X axis in my UCCNC software.
the power supplies are OK on all sides, the motor also hums........ Is my driver/card wiring correct????? (green and white wire)
My problem is that I enter the DIR PIN (O2) and the PORT (1) in the setup interface, it returns to zero as soon as I validate........ I don't understand why?
Bad settings???? bad wiring ????

Thank you for your help
Fred

Should be "2" not "O2"... then press enter and save.

What motion controller do you have? If you have a UC300, you have to use port 2 or port 3.

yes
I have the UC 300 ETH and now the recording works in the setup...
how to turn the engine manually now?

Hi
I just connected the card with a crossover cable but the computer does not recognize the utc300 eth card
Where does the problem come from ?
Thx

Maybe you forgot to setup the network card IP address.
Follow the motion controller users manual, it describes the step by step process.

yes I reread the manual from the beginning, changed my crossover cable and now everything works!!!
the first motor turn , it s a good start!!

thank you