forum.cncdrive.com

I make constant use of the Max and Min that are found on the diagnostics page.

Those DROs have been placed on the front page of my edited screenset. 855 - 893

What I would like is to have the same extents DROs for A axis.
These do not exist in the standard "fields by numbers" list in the documentation.

Could that be done with some lines in the macro loop? Or some clever way?

There must be some way to read the maximum and minimum A axis values from the loaded gcode.

At least I hope there is.

Giving this a bump just in case some clever person missed it.

I don't want to be a pest but at this time of year people can be very busy or even on holiday.

So I will bump this again just in case.