Page 1 of 1
The Limit switch is on, machine can't start.
Posted:
Mon Feb 06, 2017 11:28 pmby mazinwoodcraft
If the limit switch is on, [there's many options to get this situation] I just move axis manually or remove a switch. [looks stupid]. How can I move an axis without a physical work?
Thank you.
Re: The Limit switch is on, machine can't start.
Posted:
Tue Feb 07, 2017 4:48 amby zymurgy42
Will the Override Limts (on run page at bottom right, to the left of the RESET button), not allow this?
Re: The Limit switch is on, machine can't start.
Posted:
Fri Feb 17, 2017 9:23 amby DerRoy
Hi, yes it will.
Press override, unreset and you can move the axis away from the switch.