Z Axis brake release
2 posts
• Page 1 of 1
Z Axis brake release
by CNCChris » Wed Jul 06, 2022 3:45 am
What's the general setup for a z axis break release? Is it setup so it releases when RESET is pushed? It's a 24v brake so is it run through a relay or can one of the outputs handle it? AXBBE
- CNCChris
- Posts: 27
- Joined: Fri May 17, 2019 8:20 am
Re: Z Axis brake release
by Battwell » Sat Jul 09, 2022 12:25 pm
a brake would be via a relay and seperate 24v supply normally.
relay can be off z enable signal. or better still off brake output of your servo drive.
relay can be off z enable signal. or better still off brake output of your servo drive.
Uc300eth on router and mill.
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
- Battwell
- Posts: 867
- Joined: Sun Sep 25, 2016 7:39 pm
- Location: South Wales. Uk
2 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 16 guests