forum.cncdrive.com

Hi
I bought a complete control box from cnc drive. I have come to the connection of stepper motors. I have 2 stepper motors for my y axis. on the switch cabinet only an input with a y axis is marked, where should that stepper motor be connected?

One more thing, when I stand in front of cnc which motor should where, right left motor ??

I would wire the second Y motor to the B axis.

ger21 wrote:I would wire the second Y motor to the B axis.

Agreed.
Can I ask?.
What is a good software for doing electrical drawings like the one in the op's attachment

I think my collegue made it in Altium designer.

You can connect the motors to any motor connectors in the control box, then you have to configure the axes as per your connections.