forum.cncdrive.com

Posted: **Mon Feb 21, 2022 9:19 am**

Hello
I debute with UCCNC

I have a settings problem on the 0-10V command. :oops:

Here are the UCCNC configuration screens:

Here are the parameters of the VFD:
P3 : 400
P4 : 400
P5 : 400
P11 : 100
P72 : 400
P73 : 100
P144 : 3000

Here are the analog values identified:

What is the parameter that is not good?
Thank you for your help

Claude

Posted: **Mon Feb 21, 2022 11:42 am**

Try PWM Min Duty at 25%

Posted: **Mon Feb 21, 2022 12:45 pm**

ger21 wrote:Try PWM Min Duty at 25%

Hello
Thanks for your help
I tried to play with this parameter.
Here is the result 25%

Do you have another idea?

Posted: **Wed Feb 23, 2022 10:11 am**

I continued to look for where the problem comes from.
I made tension measurements on the AO1 exit.

As it seemed to me that the card did not deliver more than 5V to 100%, I repositioned the strap on the choice exit 0-5V.
And the it works !!!!!

I have an analog value up to 10V

But I do not understand why? :roll:

Error setting AXXBE and Huanyang HY03D023b