Page 1 of 1
Ask for homing after kill switch
Posted:
Sun Jan 16, 2022 9:53 pmby Blaise
I have setup my Kill switch to trigger the error line of the drives.
Once the kill switch is released, the drives are reset.
I would like UCCNC to ask for the machine to be homed before Cycle start can be pressed. Or a tool change can be called. Also any move using MDI. Any motion other than jog.
Any suggestion on how to go about doing this?
Thanks!
- Blaise
Re: Ask for homing after kill switch
Posted:
Sun Jan 16, 2022 10:13 pmby cseyler
In general settings
-> check mandatory homing and also reset deref home
Re: Ask for homing after kill switch
Posted:
Sun Jan 16, 2022 10:20 pmby Blaise
Thanks! That helped a lot.
Is there a way to Derek home via a macro?
Re: Ask for homing after kill switch
Posted:
Sun Jan 16, 2022 10:26 pmby ger21
Try:
exec.Callbutton(781);
Re: Ask for homing after kill switch
Posted:
Sun Jan 16, 2022 10:34 pmby Blaise
Yes!!!
exec.Callbutton(781); worked a charm!
Where did you find this information? I am curious.
Thanks!
- Blaise
Re: Ask for homing after kill switch
Posted:
Sun Jan 16, 2022 10:36 pmby ger21
UCCNC\Documentation\Buttons_by_Number
Re: Ask for homing after kill switch
Posted:
Sun Jan 16, 2022 10:42 pmby Blaise
Oh! I had an older version that did not describe buttons over 777.
Buttons from 778 to 999 were described as « reserved »
I found the latest version. Il have some reading to do!
Thanks!
Re: Ask for homing after kill switch
Posted:
Mon Jan 17, 2022 7:46 pmby cseyler
All the information about buttons, leds and fields are present in your UCCNC directory (default : c:\UCCNC\documentation)
Re: Ask for homing after kill switch
Posted:
Wed Nov 02, 2022 7:22 amby marteng
cseyler wrote:All the information about buttons, leds and fields are present in your UCCNC directory (default : c:\UCCNC\documentation)
I thought I saw them somewhere, thanks for reminding me that they were under my nose.
Marteng