My machine continuously plunges into the table when I call G28 or G53.
I can home the machine with the buttons on the screen, move the Z down, call G28, it then move up to Z zero and immediately plunges right back down.
Machine Coordinates
2 posts
• Page 1 of 1
Machine Coordinates
by CurtisCNC » Mon Nov 01, 2021 3:40 am
- CurtisCNC
- Posts: 1
- Joined: Mon Nov 01, 2021 3:32 am
Re: Machine Coordinates
by dezsoe » Mon Nov 01, 2021 7:30 pm
Please, write some more details and upload your profile to check. (How to find version numbers and the profile)
What's the problem with G53?
What's the problem with G53?
- dezsoe
- Posts: 2093
- Joined: Sun Mar 12, 2017 4:41 pm
- Location: Csörög, Hungary
2 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 23 guests