Set DRO height after probe
Posted: Sat Aug 21, 2021 3:22 pmHow do I set the dro to 19mm once z axis height probe has completed?
forum.cncdrive.com
UCCNC machine control software support forum
https://forum.cncdrive.com/
Set DRO height after probe
Page 1 of 1
Posted: Sat Aug 21, 2021 3:22 pmRe: Set DRO height after probe
Posted: Sat Aug 21, 2021 4:54 pmHow do you probe? (Probe button on main screen that calls the M31 macro or with the probe screen?)
Re: Set DRO height after probe
Posted: Sat Aug 21, 2021 6:20 pmProbing from the run screen. When I try and do it from the probing screen it just keeps Telling me that the machine hasn't been homed yet.