Floating Head Confusion
Posted: Wed Jul 21, 2021 10:29 amHI all, I am new to this forum and new to plasma cutting, currently I am building a 4x4 machine using UC300eth and UCCNC software. I have a floating head and cannot figure out how to get it to work.
This is what I am doing
Using sheetcam and the UNCC Plasma post processor I am exporting my file.
I have enabled M31 macro on UNCNC
I am not sure where in the macro to add my switch offset of 5.47
when I try to run the file I get the error The machine has not been homed home the machine before run to parking position.
Any help would be appreciated.
Many Thanks Alan
This is what I am doing
Using sheetcam and the UNCC Plasma post processor I am exporting my file.
I have enabled M31 macro on UNCNC
I am not sure where in the macro to add my switch offset of 5.47
when I try to run the file I get the error The machine has not been homed home the machine before run to parking position.
Any help would be appreciated.
Many Thanks Alan