forum.cncdrive.com

UCCNC machine control software support forum
https://forum.cncdrive.com/

Question about CAM module built into UCCNC

https://forum.cncdrive.com/viewtopic.php?f=2&t=3279

Page 1 of 1

Question about CAM module built into UCCNC

PostPosted: Sun Jun 20, 2021 1:15 am
by The-Meerkat
I've never seen any operating instructions for the CAM tab in UCCNC. I have not seen any posts here either. I'm wondering if anyone uses it? How is it? Where can I find info? :mrgreen:

Re: Question about CAM module built into UCCNC

PostPosted: Sun Jun 20, 2021 2:46 am
by cncdrive
It is in the UCCNC/Documentation folder of your installation.
All documentation is there.

Re: Question about CAM module built into UCCNC

PostPosted: Sun Jun 20, 2021 9:42 pm
by The-Meerkat
:shock: :shock: :shock:

I didn’t know about the documentation folder. It looks like there is some good reading for me there. It’ll probably answer a lot of my dumb questions. I’m excited about that.

Thanks.
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/