autolevel plugin
Posted: Sun May 16, 2021 10:31 amhello,
i would like to test the autoleveler plugin from cahib. i was looking through the forum but found it hard to find out which version of the plugin is actually working with uccnc 1.21010 or later. as i understood version 3 is on the way but at the moment downloadable but not working.
could somebody point out which version actually works with which versions? remember i need uccnc version 1.21010 or higher.
thanks,
michael
i would like to test the autoleveler plugin from cahib. i was looking through the forum but found it hard to find out which version of the plugin is actually working with uccnc 1.21010 or later. as i understood version 3 is on the way but at the moment downloadable but not working.
could somebody point out which version actually works with which versions? remember i need uccnc version 1.21010 or higher.
thanks,
michael