forum.cncdrive.com

UCCNC machine control software support forum

Skip to content

Camera crosshair Personalization

Post anything you want to discuss with others about the software.
Post a reply

Camera crosshair Personalization

Postby silverdog » Sat May 08, 2021 1:50 pm

Hi,
Is it possible to change the size (strenght) and color of the crosshair camera target? I find a bit difficult to see it on some part surfaces.
Thanks
Attachments
Capture.JPG
silverdog
 
Posts: 11
Joined: Thu Jan 19, 2017 10:10 pm
Top
Post a reply

Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 22 guests

Powered by phpBB® Forum Software © phpBB Group