Probing error
Posted: Thu Dec 29, 2016 5:09 pmHi All,
I am new to this forum and UCCNC and UC300-5LPT USB motion controller so if the question seems stupid than please laugh and help me at the same time. I have setup probe in uccnc and it seems to work fine but after measuring the z hight it adds 1 mm to the length.I am using the default M31 Macro. I can't where the 1 mm is added also the tool table is not updated either.
I am new to this forum and UCCNC and UC300-5LPT USB motion controller so if the question seems stupid than please laugh and help me at the same time. I have setup probe in uccnc and it seems to work fine but after measuring the z hight it adds 1 mm to the length.I am using the default M31 Macro. I can't where the 1 mm is added also the tool table is not updated either.