v carve pro
Posted: Thu Apr 08, 2021 5:02 pmWill I have trouble working in inches with this program? They only have a post for uccnc(mm)...
forum.cncdrive.com
UCCNC machine control software support forum
https://forum.cncdrive.com/
v carve pro
Page 1 of 1
Posted: Thu Apr 08, 2021 5:02 pmRe: v carve pro
Posted: Thu Apr 08, 2021 8:49 pmIf your UCCNC is setup to work in mm then you can work in imperial in Vcarve and use UCCNC post processor for mm.
Re: v carve pro
Posted: Thu Apr 08, 2021 9:12 pmYou can also very easily create an inch post processor if you work in inches in V Carve, and have UCCNC setup in inches.
Re: v carve pro
Posted: Fri Apr 09, 2021 9:37 amYou can also use the Mach2/3 Arcs inch PP. This what I use and I have no issues.
Re: v carve pro
Posted: Sat Apr 10, 2021 9:01 pmThanks to eveyone. I discovered there is a standard gcode pp in inches for v carve.