In searching earlier posts, it looked like there was talk about getting a device profile for the UCCNC controller. I believe in Jan it was stated that it would take about another month.
Has there been any progress on this? Is it still on the horizon?
Lightburn device for UCCNC controller
1 post
• Page 1 of 1
Lightburn device for UCCNC controller
by George M » Thu Mar 25, 2021 11:09 pm
Thank you
George M
DIY CNC Machine
UCCNC
UC300eth-LPT5
UCBB
George M
DIY CNC Machine
UCCNC
UC300eth-LPT5
UCBB
- George M
- Posts: 52
- Joined: Mon Apr 29, 2019 6:49 pm
1 post
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 27 guests