forum.cncdrive.com

Hi there, my UCCNC Ver 1.2111 always starts with the default profile, I then load my profile and try to create desk top short cut apply and save, it will run with my profile but when I
shut down and start again it will start with the default profile again, am I missing something or is there another setting some where that I should try. I know when I was using the previous version I actually had an icon on the desk top with my profile, but I can't seem to be able to do it again.

Cheers
Nick

front section of the uccnc users manual tells you how to set up switches in the shortcut to load profiles and motion controllers

Thanks Robert, it's amazing what one can find out by just taking the time to read the manual....(when all else fails read the manual)
Cheers
Nick

naijin wrote:Thanks Robert, it's amazing what one can find out by just taking the time to read the manual....(when all else fails read the manual)
Cheers
Nick

RTFM means something for a reason.