Probe 2 and UC-100
Posted: Tue Dec 20, 2016 12:22 pmCan you add Probe 2 to the UC-100 screen set. I was going to use an unused home pin (13) for the tool setter. I only use home switches on X and Y.
Thanks
Derek
Thanks
Derek
forum.cncdrive.com
UCCNC machine control software support forum
https://forum.cncdrive.com/
Probe 2 and UC-100
Page 1 of 1
Posted: Tue Dec 20, 2016 12:22 pmRe: Probe 2 and UC-100
Posted: Wed Dec 21, 2016 2:56 pmbump
Re: Probe 2 and UC-100
Posted: Wed Dec 21, 2016 4:20 pmHi Derek,
I can't answer this question now unfortunately, because we will have to check the UC100 firmware first to see if it will fit.
Why I can't check it now is because my collegue who is the head of the API/firmwares development for the UCCNC had some holidays left this year and he pulled them now to extend his Christmas holidays a bit,
so he is already on holidays and I myself or other collegues could not make a 100% clear decision about this (or better to say it is better if we leave this on the collegue), so it is better to wait the next year start to answer this question with confidence.
And the Christmas holidays are close, our last working day this year will be the 22th (tomorrow), so if we can implement this then sure we can do it only next year.
Will start working again early this year, on the 2nd January.
I can't answer this question now unfortunately, because we will have to check the UC100 firmware first to see if it will fit.
Why I can't check it now is because my collegue who is the head of the API/firmwares development for the UCCNC had some holidays left this year and he pulled them now to extend his Christmas holidays a bit,
so he is already on holidays and I myself or other collegues could not make a 100% clear decision about this (or better to say it is better if we leave this on the collegue), so it is better to wait the next year start to answer this question with confidence.
And the Christmas holidays are close, our last working day this year will be the 22th (tomorrow), so if we can implement this then sure we can do it only next year.
Will start working again early this year, on the 2nd January.
Re: Probe 2 and UC-100
Posted: Thu Dec 22, 2016 12:56 amcncdrive wrote:And the Christmas holidays are close, our last working day this year will be the 22th (tomorrow), so if we can implement this then sure we can do it only next year.
Will start working again early this year, on the 2nd January.
Hope you have a good Christmas Balazs, and wish Daddy Balazs one too. Hope he enjoys his time with his little one.
And Merry Christmas to everyone else.
Keith
Re: Probe 2 and UC-100
Posted: Thu Dec 22, 2016 4:09 pmThank you Keith.
I'm wishing you the same, a Merry Christmas and a great and happy New Year.
And I'm wishing to all of you guys on this forum the same!!!
I'm wishing you the same, a Merry Christmas and a great and happy New Year.
And I'm wishing to all of you guys on this forum the same!!!