forum.cncdrive.com

Hi all, this is my first post, as a newbee in this world.
I am trying to build my first Router, and have a lot of fun with this

I have a simphonix e500 VFD for my spindel, and want to controll it from UCCNC with my UC300eth controller. The speed can be controlled in servels ways but what will be the best way ?
options are: digital, rs485, 0-10vdc, 0-20ma

The manual for E500 is to big to upload, but here is a link
http://www.sunfars.com/download_l.aspx? ... d=29&Fid=1

Thanks in advanced

Best Regards Palle

Analog out on 15 pin analog port of uc300 is what I use and works well.
To calibrate it use minimum pwm value.

Thanks for answer, I will go with that