Laser

[naijin]

I have installed a diode laser to my home made cnc router, using AXBB-E controller, I can turn the laser ON and Off using the spindle CW and CCW buttons but I have no idea how to use M10 and M11 commands to increase or decrease the power level
of the laser, can some one point me in the right direction please? also I am using VCarve Pro, is there a post processor availble for UCCNC, I tried the one in VCP called Laser Arcs Atc(mm)(*.din) but I could not get it to work.
Nick

[Tweakie.CNC]

If it's any help the Vectric Laser pp that I use is attached.

Tweakie.

[naijin]

Thank you very much Tweakie, I will try it out tomorrow.