Page 1 of 1
Fusion360 Post processor with probing functions
Posted:
Sat Jun 20, 2020 4:23 amby Delco
Does anyone have a working post processor to use the fusion360 probing functions ?
I have found this website that has a mach3 post processor but it doesnt work with uccnc.
http://www.mlmsolutions.biz/fusion_post ... robing.php
Re: Fusion360 Post processor with probing functions
Posted:
Sun Jun 28, 2020 3:58 amby spinelli
This is on my wishlist too. I use a Drewtronics probe and would love to automate the probing process.
Re: Fusion360 Post processor with probing functions
Posted:
Sun Jun 28, 2020 8:32 pmby cncdrive
There is a nice probing screen in the UCCNC development version, you can use that.
Or you could send an email to Autodesk, ask them to make their post processor compatible.
I'm sure they will if many of you guys will ask them.
Re: Fusion360 Post processor with probing functions
Posted:
Wed Jul 01, 2020 7:00 pmby CL_MotoTech
Honest question about this, I have never used CAM to operate the probing operations, what is the benefit of doing this in CAM?
Re: Fusion360 Post processor with probing functions
Posted:
Thu Jul 02, 2020 8:50 amby Delco
Can be used to check you have machined to the correct dimension , cycles to check for tool breakage , when finding the centre of a part distances to travel are set in cam not manually .