forum.cncdrive.com

Posted: **Thu Jan 23, 2020 9:22 pm**

IS there any chance of gettting an analog UCCNC controller ? Or at least a S/D to analog convertor card to use with a UCCNC controller and analog servo drives.

Just a thought, (;-) TP

Posted: **Thu Jan 23, 2020 11:00 pm**

Larken sells step/dir to analog boards.

Posted: **Fri Jan 24, 2020 12:30 am**

Was looking for something made by UCCNC.

(;-) TP

Posted: **Sat Jan 25, 2020 9:36 am**

ive been waiting for this for years :-)

i have it working via a galil motion controller but it was hard to do first setup
and they are expensive! luckily i have a load of them here from early mach3 analog conversions.

forum.cncdrive.com

Analog UCCNC controller

Analog UCCNC controller

Re: Analog UCCNC controller

Re: Analog UCCNC controller

Re: Analog UCCNC controller