forum.cncdrive.com

Hi there, I have just received my new pc, down loaded and installed UCCNC, I have a uc100, copied all the profiles,
screens and plug ins from the old pc, licence as well, BUT every time I start the program it runs in Demo Mode, I have re-installed every thing twice so far
with no luck, the uc100 has a green light "on" but no luck, any suggestions or instructions will be greatly appreciated.

Happy New Year 2020

Nick

I think uccnc installs a dummy license.txt file for demo mode. Are you sure you got the license file coppied? Can you get original license you got in email?

Eric

I was hoping that it was the original one, I don't think I have any other licences, I will keep on trying to install it again, if it fails
then I will have to down load the latest version, but I will not be able to use Gery1's screen 2017.

Nick

If uccnc installs and runs, you Don't need to download and reinstall, you need to find your license file.

Check your old uccnc folder again for other .txt files that may be your license.

Regards
Eric

Problem solved, replaced usb cable and all went well !!

Nick