forum.cncdrive.com

I just upgraded to 1.2111 and inside the user manual, in section 2.2.3 there's a reference to a file "Labels_by_number.htm".

I do not have this file in my Documentation directory.

As a side note, I also noticed that the Current Hi/Low pin is no longer on the "I/O Setup" tab as it was with 1.2049.

The user manual shows it on page 27, but I do not have the same screen.

How can I use this functionality with version 1.2111?

The Latest Test version current Hi_Lo setup is in teh Axis config section for EACH axis. AND yes you can set it to teh same pin/port for each axis so you ONLY use 1 output.

(;-) TP

Check teh Fields_ByNumber HTM that might be what you are looking for.

(;-) TP

Thank you very much. Very helpful !!!!!!!!

I also just noticed the prior user manual is still present in the directory, even though all other remnants of that version seem to be gone. I think I was occasionally crossing between the new and old manual by accident.