forum.cncdrive.com

Is there a way to have uccnc ask if you want to (start spindle?) and follow spindle spin up delay before moving axis, if program was stopped mid cycle and then cycle start selected?

Thank you.

Use Run from here, or start the spindle before using Cycle Start.

^^ Yes correct, most of my machine customers don't have cnc experience and their employees don't always pay attention...


Can code be added to Cycle Start button to check Actual Line # and if greater than 0 or 1 then execute run from here?

Or replace the Cycle Start button with a different button with the code to check Actual Line # and then execute Cycle Start or Run From Here if line number over 1.

Thank you