Page 1 of 1
PC Crashed, UCCNC Won't Recognize My UC400ETH
Posted:
Mon Feb 04, 2019 9:06 pmby jtb223
My PC crashed and I needed to reload Win10. I reloaded UCCNC but it won't recognize my UC400ETH. When I run UCCNC the blue LED blinks once but the software only allows me to enter the demo mode. Any suggestions?
Re: PC Crashed, UCCNC Won't Recognize My UC400ETH
Posted:
Mon Feb 04, 2019 10:04 pmby cncdrive
Setup the network IP as described in the UC400ETH manual.
The blue LED blinks once because the UC400ETH gets the broadcast message when the UCCNC explores all motion controllers connected to the PC.
Re: PC Crashed, UCCNC Won't Recognize My UC400ETH
Posted:
Tue Feb 05, 2019 1:05 amby jtb223
Thanks. Back up and running.