Hello,
I have 4th axis install.
I use softlimits for XYZ axis but i dont want to enable it for A axis because it will turn constantly when milling.
Now i just set limits to -99999999 and +99999999.
But i want to turn off A axis soft limit not cheat it ;p.
Soft limit for A Axis
3 posts
• Page 1 of 1
Soft limit for A Axis
by Kivlow » Sun Jan 20, 2019 11:50 am
- Kivlow
- Posts: 10
- Joined: Fri Jan 11, 2019 7:18 am
Re: Soft limit for A Axis
by jerjer2018 » Sat Feb 02, 2019 5:52 am
Did you disable A here??
- Attachments
-
- jerjer2018
- Posts: 9
- Joined: Sat Jan 19, 2019 9:28 pm
Re: Soft limit for A Axis
by dezsoe » Sat Feb 02, 2019 9:27 am
jerjer2018, That is the homing sequence setting and it doesn't change any soft limit setting.
Kivlow, At the moment the soft limits can be enabled or disabled to all axes together.
Kivlow, At the moment the soft limits can be enabled or disabled to all axes together.
- dezsoe
- Posts: 2093
- Joined: Sun Mar 12, 2017 4:41 pm
- Location: Csörög, Hungary
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: Bing [Bot] and 16 guests