forum.cncdrive.com

Hi, am a newbie and at my wits end! In Fusion 360 I have installed the UCCNC post (I think, see pic) but in the NC editor, nothing appears? Any ideas, cheers.

I don't think you've actually selected a post processor.

Just an FYI so someone else doesn't make a dumb mistake like I did, I think one of the Fusion updates allows you to select metric or inch on the CAM output. Was thinking in the past it just defaulted to the setup version. Anyway, with nothing selected, it spit out inch mode and my machine is setup for metric. Took me a little while (and help from this forum) to figure out while there was a tool path in UCCNC....LOL...it was there, just too tiny to see it.

Anyway, figured I'd pass on my ignorant moment if it saves someone else a headache.